This MSDS covers part numbers 50012QL for
Tap Magic Formula 1 "Aqueous" Cutting Fluid Aerosol.
Click for a printable PDF.
MATERIAL SAFETY DATA SHEET
U.S. DEPARTMENT OF LABOR, OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, HAZARD
COMMUNICATION STANDARD, 29 CFR 1910.1200
The Steco Corporation
2330 Cantrell Road
P.O. Box 2238
Little Rock, AR 72203
Emergency Response: (800) 255-3924
Information: (800) 643-8026
Fax #: (501) 374-4278
Date Reviewed: March 12, 2009
TRADE NAME: TAP MAGIC Formula 1 "Aqueous" Cutting Fluid Aerosol
CHEMICAL NAME & SYNONYMS: COMPLEX MIXTURE
DOT SHIPPING NAME: Aerosol, ORM-D
HMIS/NFPA CODE: Health 1; Fire 0; Reactivity 0
MANUFACTURING CODE NO.: 8358
COMMODITY CODE NO.: 332-9150
I. HAZARDOUS COMPONENTS
Cellulose Ether: CAS # 9032-42-2 • OSHA PEL, (N/A) • ACGIH TLV,
10mg/M3 • Other limits recommended, (N/A) • Max. %, <1.
Phosphate Ester: CAS # 39464-70-5 • OSHA PEL, (N/A) • ACGIH TLV, (N/A) • Other limits recommended, (N/A) • Max. %, <3.
Triethanolamine: CAS # 102-71-6 • OSHA PEL, (N/A) • ACGIH TLV, (N/A) • Other limits recommended, (N/A) • Max. %, <4.
Amine Complex: CAS # 141-43-5 • OSHA PEL, 3mg/M3 • ACGIH TLV, (N/A) • Other limits recommended, 3 ppm TWA • Max. %, <3.
Benzoltriazole: CAS # 95-14-7 • OSHA PEL, (N/A) • ACGIH TLV, (N/A) • Other limits recommended, (N/A) • Max. %, <1.
Alkoxylated Fatty Alcohol: CAS # 69227-21-0 • OSHA PEL, .2mg/M3• ACGIH TLV, (N/A) • Other limits recommended, (N/A) • Max. %, <5.
Water: Max. % <85
Hydrocarbon Propellant: Max. % <3
* These products do not have regulatory limit; the OSHA PEL for general oils and dusts is 5mg/M3.
II. PHYSICAL DATA
BOILING RANGE, (760 mm, Mercury): 100 degrees C
SPECIFIC GRAVITY (Water =1), lbs/gal.: 1.05
VAPOR PRESSURE (mm of Mercury) @ 68 degrees F: 17.5
VAPOR DENSITY (Air = 1): 1
SOLUBILITY IN WATER, % by weight: 100
EVAPORATION RATE (Water = 1): 1
% VOLATILE BY VOLUME: 90
APPEARANCE: Viscous amber liquid
ODOR: Mild sweet
pH: 9.3
III. FIRE & EXPLOSION DATA
FLASH POINT, TOC, TCC, PMCC: None
AUTOIGNITION TEMPERATURE: None
EXTINGUISHING MEDIA: Not Applicable
SPECIAL FIRE FIGHTING PROCEDURES: Plastic containers may rupture, melt or
ignite when exposedd to open flame or excessive heat.
UNUSUAL FIRE AND EXPLOSION HAZARD: This product may release toxic fumes when
burned; including but not limited to carbon monoxide, phosphorus oxides, ammonia,
short chain organics.
IV. HEALTH HAZARD INFORMATION
PRIMARY ROUTES OF ENTRY: Exposure may occur via inhalation of mist, skin contact
or ingestion.
EFFECTS OF ACUTE OVEREXPOSURE:
INHALATION – Vapor or mist from heated material may cause
irritation of the respiratory tract, experienced as nasal discomfort and discharge,
with chest pain, coughing and eye irritation.
SKIN CONTACT – Prolonged or repeated exposure may cause irritation,
defatting, & redness. In severe cases pain and swelling may occur.
INGESTION – May cause burning or painful sensations in the mouth, throat,
chest, and abdomen, nausea, vomiting and diarrhea. May cause dizziness, drowsiness,
faintness, weakness, collapse, and coma.
EYE CONTACT – May cause irritation, experienced as stinging with excess
blinking and tear production. Excess redness and swelling of the conjunctiva
may occur.
EFFECTS OF CHRONIC OVEREXPOSURE:
SKIN CONTACT – May cause sensitization and an allergic
skin reaction in a small proportion
of individuals. May aggravate disorders of the kidneys.
CARCINOGENICITY: Not a carcinogen or suspect carcinogen.
EMERGENCY AND FIRST AID PROCEDURES:
INHALATION – Remove to fresh air. If not breathing, give artificial
respiration. Call a
physician.
SKIN CONTACT – Remove contaminated clothing. Wash skin with soap and
water. Obtain medical attention if irritation persists. Wash clothing before
reuse.
INGESTION – Do not induce vomiting. Rinse mouth with water or dilute
vinegar. Dilute stomach contents by drinking water. If vomiting occurs spontaneously,
keep head below hips to prevent aspiration. Call a physician immediately.
EYE CONTACT – Immediately flush eyes with water and continue washing
for several minutes. Remove contact lenses, if worn. Obtain medical attention.
.
V. REACTIVITY DATA
STABILITY – Stable at ambient temperatures and pressures.
INCOMPATIBILITY – Material is alkaline and therefore, contact with acidic
materials should be avoided. Do not mix this product with nitrites to avoid
formation of carcinogenic nitrosamines. Avoid contact with strong oxidizing
agents, strong acids or bases, aldehydes, ketones, acrylates, organic anhydrides,
and organic halides.
HAZARDOUS DECOMPOSITION PRODUCTS – If exposed to open flames, the following
products are among those that can be produced: oxides of carbon (carbon monoxide
and carbon dioxide) and nitrogen, ammonia and organic amines, aldehydes and
phosphoric acids.
CONDITIONS CONTRIBUTING TO HAZARDOUS POLYMERIZATION – None
VI. DISPOSAL, SPILL OR LEAK PROCEDURES
AQUATIC TOXICITY – Not determined, but believed to be low.
SPILL OR LEAK PROCEDURES – For small spills, soak up with shop towels
or other cellulose-based material. Avoid contact with the skin and eyes. For
large spills, procedures are same as for small spills, but may require protective
clothing and equipment to minimize contact.
WASTE DISPOSAL METHOD – This is of concern only for a quantity exceeding
many gallons of material. Dispose of in accordance with all local, state and
federal regulations. Incineration is acceptable where permitted under law.
NEUTRALIZATION CHEMICALS – Dilute acids: vinegar, etc.
VII. SPECIAL PROTECTION INFORMATION
EYE PROTECTION – Standard eye protection should be worn when using this
product. Monogoggles. Avoid contact lenses when working with any chemical.
SKIN PROTECTION – Protective gloves (butyl or PVC coated) should be
worn if prolonged or repeated skin contact occurs or is anticipated.
RESPIRATORY PROTECTION – Not required under normal use conditions. Use
self-contained breathing apparatus in high mist concentrations or during fire
fighting procedures.
VENTILATION – General (mechanical) room ventilation is expected to be
satisfactory for use at room
temperatures.
VIII . SPECIAL PRECAUTIONS
Do not breathe vapor or mist. Do not get in eyes, on skin, or clothing. Do
not swallow. Wash thoroughly after handling. Keep container closed when not
in use. Keep from freezing, this may damage container or cause product to
separate, making it unsuitable for use. Keep out of reach of children. Repeated
exposure may cause liver and kidney damage. Any fluid can be “overworked”
or “overheated”, causing it to break down. This overuse is identified
by the sight of or strong odors, vapors or fumes not normally present. The
effects of these vapors have not been fully determined. After use of this
product, clean and lubricate metal surfaces to avoid staining and/or corrosion.
IX. ADDITIONAL INFORMATION
Toxic Substances Control Act (TSCA) STATUS: The ingredients of this product
are on the TSCA inventory. CALIFORNIA Proposition 65: This product contains
no listed substances known to the State of California to cause cancer, birth
defects or other reproductive harm, at levels, which would require a warning
under the statute.
___________________________________________________________________________________________________________
Prepared by: Asa L. Morton, Chief Chemist, American Interplex Corp, Little
Rock, AR 72204 (501) 224-5060
| Tap
Magic Xtra-Foamy |
  |
|
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||